Wieland ZENOTEC FIRE P1
Zenotec Fire P1 fast sintering program:
! Only suitable for Zenostar T/MO single-tooth restorations !
Temperature 1 [°C] / [°F] Temperature 2 [°C] / [°F] Heating rate [°C/h] / [°F/h] Holding time [h]
Heating phase 20 / 68 1520 / 2768 1500 / 2732 -
Holding phase 1520 / 2768 1520 / 2768 - 0.5
Cooling phase 1520 / 2768 300 / 572 800 / 1472 -
For the sintering process in the Zenotec high-temperature furnaces, the following points should be observed:
If a standard program is used, it is recommended to sinter the restorations on a sintering support base plate under a highpurity
Al2O3 cover. This arrangement helps prevent deformation and discoloration from occurring in the restoration. All
standard sintering programs are matched to this configuration.
If a fast sintering program is used, only the sintering support base plate - without the cover - must be used. Fast sintering
is only suitable for ZenostarT/MO single-tooth restorations.
Check sintering auxiliaries regularly to make sure that they are clean and work properly